• Management Pack:  Windows Server DHCP
  • MP Version:  6.0.7295.0
  • Released:  8/21/2015
  • Publisher:  Microsoft

DHCP Technical Preview IPv6 Runtime Static Address Required Monitor Monitor

  • ID:  Microsoft.Windows.DHCPServer.6.4.IPv6Runtime.UnitMonitor.StaticIPAssigned
  • Description:  This monitor checks for the required configuration to initialize IPV6 scopes to got a static IP address being asigned for the server
  • Target:  DHCP Technical Preview IPv6 Runtime
  • Enabled:  Yes

Operational States

Name State Description
Event Raised Error  
Manual Event Raised Success  

Alert Details

Monitor State Message Priority Severity Auto Resolution
Event Raised (Error) DHCP Technical Preview IPv6 Runtime Static Address Required Alert Medium Match Monitor Health Yes

Run As Profiles

Name
Default

Monitor Knowledgebase

Summary

The Dynamic Host Configuration Protocol version 6 (DHCPv6) Server service is a process that runs in the background on a computer running Windows Server and that provides Internet Protocol version 6 (IPv6) addresses to clients.

Dynamic Host Configuration Protocol (DHCP) can lease both Internet Protocol version 4 (IPv4) and Internet Protocol version 6 (IPv6) addresses. If IPv6 is not available, the DHCP service uses IPv4 only.

Causes

DHCP failed to initialize one of its components. The DHCP Server service cannot start. Client computers cannot obtain new leases from the DHCP server and will not have network connectivity.

Resolutions

Resolution: Configure a static IP address for the DHCP server

To perform these procedures, you must be a member of the Administrators group, or you must have been delegated the appropriate authority.

To configure TCP/IP for static addressing:

  • At the DHCP server computer, click Start, click Control Panel, double-click Network and Sharing Center, and then click Manage network connections.

  • Right-click the network connection you want to configure, and then click Properties.

  • On the Networking tab, click Internet Protocol Version 6 (TCP/IPv6), and then click Properties.

  • Click Use the following IP address, and then type the IP address, subnet mask, and default gateway.

  • Click Use the following DNS server addresses.

  • In Preferred DNS server and Alternate DNS server, type the primary and secondary DNS server addresses.

External References
This monitor does not contain any external references.

See Also for Windows Server DHCP Management Pack


Downloads for Windows Server DHCP Management Pack

AZURE OPTIMIZATION ASSESSMENT GET STARTED
MIGRATION TO AZURE GET STARTED
SYSTEM CENTER MIGRATION TO AZURE GET STARTED
MIGRATION TO AZURE FOR SQL AND WINDOWS 2008 GET STARTED